переводить не буду, думаю все английский знают
но здесь автор пишет про большие проблемы симметрии кузова и качества литья, вообщем его итог-предстоит много работы.
When I finally got my kit lately, the first part I checked was the front hood, the "face" of any car and therefore maybe it's most important part. What I saw was that the mould must have been assembled in a bad way, for there was a large step at the parting line on the side of the fenders. Next I noticed some problems in symmetry, especially at the front light areas and the mountings for the wheel wells. Furthermore, if the resin is checked against the light, you can see many areas that have been filled with putty but also bubbles in the material that haven't surfaced completely. If left like that, those bubbles will most likely be visible after painting.
After checking the other parts roughly, I found that they have similar problems.
I concluded that building this kit to a model car that meets my standards would involve a lot of time and work. And in my opinion, too much of that time would have to be spent correcting and preparing the parts, something that is not acceptable for me. It might be acceptable for somebody else, and it might be even the kind of challenge somebody is looking for, and I wish those all the best with the build.
As for me, I have put it on ebay immediately for the price I paid; the offer's good until Sunday.
Это с сайта Scalemotorcars
что интересно, автор не стал связываться с этим китом , а сразу выставил его на аукцион , я думаю это что то значит.
Отредактировано igorets (03-02-2014 17:52:33)