Я как раз пробую разные лаки на водной основе..
Пока результаты очень средние. Советую тоже пробовать на кошках сначала. Думаю тут много ньюансов. Сам лак, чем разбавлять и какими слоями наносить.. Думаю самое важное - это в первом слое не "поднять" хлопья хрома с поверхности. А далее можно смелее..
Если кто поделится опытом по нанесению лака на хром, буду признателен. Есть водные лаки Футура, Valejjo, Mr Hobby H30 и Tamiya X22 (почти-на-водной-основе)
Кстати
На сайте http://www.swannysmodels.com/Alclad.html эта тема обсуждалась тоже. Вот цитата
Clear Coats and Decals on Alclad
Unlike most conventional paint finishes you do not need to seal the surface of an Alclad paint job prior to applying decals. In fact if you put just a regular coat of clear coat on the surface you will actually detract from the final appearance. You can simply go straight to applying decals and do not need to seal them afterwards. I would not recommend using Future as a decal setting agent in this instance as it will leave a very noticeable mark on the finish. However, like most rules there is an exception to this one. If you want a finish that really glows then you can use Future but you will have to add a good amount of elbow grease along with it. Here is the idea, after all decals have been applied seal the model with Future and let cure overnight. Now buff the entire model with very fine sandpaper, 1800 to 2000 grit. Recoat with Future and let cure overnight. Buff out the model yet again and seal yet again with future. You’ll want to do this about FIVE times but in the end you will have a glass surface like finish that simply glows, lots of work if you’re into that kind of thing
Собственно это именно то, что я хочу опробовать
Отредактировано VolshebNik (04-11-2010 18:48:13)
Golden Model 2018. 17-19 Августа. Рига.